As a Pumps And Motors Manufacturer, share with you.While a hydraulic pump is connected to a prime mover, with the pump shaft with no extra radial load, the hydraulic motor is connected to the load via pulleys, sprockets and gears, so its main shaft can bear an increased radial load. Read More

Both pneumatics and hydraulics are applications of fluid power. Pneumatics use an easily compressible gas such as air or other sorts of suitable pure gas—while hydraulics uses relatively incompressible liquid media such as hydraulic or mineral oil, ethylene glycol, water, or high temperature fire-resistant fluids. Read More

As a hydraulic piston pump and motor manufacturer , share with you. Pump is driven by motor only. A pump does not convert one form of energy to a different form of energy, but the Motor converts electrical energy to mechanical energy. A pump requires a driving mechanism such as a motor or an engine to operate. The pump is a device that is used to move fluids. Read More

Hydraulic Valves Description: There are nearly as many types of hydraulic valves as there are ways to actuate them. You have solenoid valves, flow control valves and pressure control valves as the three primary groups of valves. Hydraulic Valves open and close, just as other valves, but these are more dynamic, with linear rise and fall of performance, based on the pressure acting upon them. Most pressure valvesare normally closed, meaning that it takes a rise in pressure to open them. However, the pressure-reducing valve is the only one that closes when pressure rises above a set point. Read More